Large strain, high rate semi-solid deformation of high density polyethylene at elevated temperatures 机翻标题: 暂无翻译,请尝试点击翻译按钮。

来源
Polymer engineering and science
年/卷/期
2018 / 58 / 9
页码
1516-1522
ISSN号
0032-3888
作者单位
Queens Univ Belfast, Sch Mech & Aerosp Engn, Belfast BT9 5AH, Antrim, North Ireland;Queens Univ Belfast, Sch Mech & Aerosp Engn, Belfast BT9 5AH, Antrim, North Ireland;Queens Univ Belfast, Sch Mech & Aerosp Engn, Belfast BT9 5AH, Antrim, North Ireland;Queens Univ Belfast, Sch Mech & Aerosp Engn, Belfast BT9 5AH, Antrim, North Ireland;
作者
McKelvey, D.;Menary, G. H.;Martin, P. J.;Yan, S.;
摘要
High density polyethylene (HDPE) is predominately processed from the molten state. However, there is the potential to enhance the mechanical properties by forming below the melt temperature, in the semi-solid phase. To further investigate this enhancement, HDPE sheets were deformed under constant width, simultaneous equal-biaxial (EB), and sequential biaxial deformation. The samples were deformed at strain-rates, from 4 to 16 s(-1), up to nominal strains of 3.0 at temperatures below 130 degrees C. The strain-rate and high-strain level applied were chosen so that the data was comparable to the thermoforming process. It was discovered that in order for the HDPE sheet to deform at the high-rate and high strains the processing temperature must be between 126 degrees C and 130 degrees C. This resulted in a processing window that was particularly small, 5 degrees C, and that within this window a temperature change of 1 degrees C had a significant impact on the stress-strain response. The samples were analyzed post deformation, where the elastic modulus was found to increase by a factor of 2.08 in the machine direction, when deformed via EB at 129 degrees C. The results showed that HDPE can be deformed to strain levels comparable to the thermoforming process. POLYM. ENG. SCI., 58:1516-1522, 2018. (c) 2017 Society of Plastics Engineers
机翻摘要
暂无翻译结果,您可以尝试点击头部的翻译按钮。
若您需要申请原文,请登录。

最新评论

暂无评论。

登录后可以发表评论

意见反馈
返回顶部