PRELIMINARY ASSESSMENT OF MORPHING WINGLET AND FLAP TABS INFLUENCE ON THE AEROELASTIC STABILITY OF NEXT GENERATION REGIONAL AIRCRAFT 机翻标题: 暂无翻译,请尝试点击翻译按钮。

会议集名/来源
Proceedings of the ASME Conference on Smart Materials, Adaptive Structures and Intelligent Systems 2018: SMASIS 2018, September 10-12, 2018, San Antonio, Texas, USA, volume 1. Development and Characterization of Multifunctional Materials; Modeling, Simulation, and Control of Adaptive Systems; Integrated System Design and Implementation
出版年
2018
页码
V001T04A02-V001T04A02
会议地点
San Antonio
作者单位
Department of Industrial Engineering, Aerospace Division, University of Naples "Federico II"Adaptive Structures Division, Italian Aerospace Research Center (CIRA)Department of Industrial Engineering, Aerospace Division, University of Naples "Federico II"Adaptive Structures Division, Italian Aerospace Research Center (CIRA)Department of Industrial Engineering, Aerospace Division, University of Naples "Federico II"
作者
Maria Chiara Noviello;Ignazio Dimino;Francesco Amoroso;Antonio Concilio;Rosario Pecora
摘要
Future aircraft wing technology is rapidly moving toward flexible and morphing wing concepts capable to enhance aircraft wing performance in off-design conditions and to reduce operative maneuver and gust loads. However, due to the reduced stiffness, increased mass, and increased degree of freedom (DOF), such mechanical systems require advanced aeroelastic assessments since the early design phases; this appears crucial to properly drive the design of the underlying mechanisms since the conceptual phase by mitigating their impact on the whole aircraft aeroelastic stability. Preliminary investigations have shown that the combined use of adaptive flap tabs and morphing winglets significantly improves aircraft aerodynamic performance in climb and cruise conditions by the order of 6%. Additionally, by adapting span-wise lift distributions to reduce gust solicitations and alleviate wing root bending moment at critical flight conditions, significant weight savings can also be achieved. Within the scope of Clean Sky 2 Air green 2 project, flutter and divergence characteristics of a morphing wing design integrating adaptive winglets and flap tabs are discussed. Multi-parametric flutter analyses are carried out in compliance with CS-25 airworthiness requirements (paragraph 25.629, parts (a), (b), (c) and (d)) to investigate static and dynamic aeroelastic stability behavior of the aircraft. The proposed kinematic systems are characterized by movable surfaces, each with its own domain authority, sustained by a structural skeleton and completely integrated with EMA-based actuation systems. For that purpose, a sensitivity analysis was performed taking into account variations of the stiffness and inertial properties of the referred architectures. Such layouts were reduced to a stick-equivalent model which properties were evaluated through MSC-NASTRAN-based computations. The proprietary code SANDY 4.0 was used to generate the aero-structural model and to solve the aeroelastic stability equations by means of theoretical modes association in frequency domain. Analyses showed the presence of critical modal coupling mechanisms in nominal operative conditions as well as in case of system malfunctioning or failure. Design solutions to assure clearance from instabilities were then investigated. Trade-off flutter and divergence analyses were finally carried out to assess the robustness of the morphing architectures in terms of movable parts layout, mass balancing and actuators damping.
机翻摘要
暂无翻译结果,您可以尝试点击头部的翻译按钮。
若您需要申请原文,请登录。

最新评论

暂无评论。

登录后可以发表评论

意见反馈
返回顶部